TA Triumph-Adler DCC 2520 - Manual (Page 258)

System Menu
7-10
4 Press [Close] to save settings or [Back] to cancel settings. The display returns to the Copy Default
screen.
Setting Margin Defaults
Set margin the width default values. The setting ranges are as follows.
For further details about margin mode, refer to page 1-17.
1 Referring to Accessing the Copy Default screen on page 7-2, access the Copy Default screen.
2 Press [S] or [T] to select Default margin width and press [Change #].
3 Press [S], [T], [W] or [X] to set the margin width.
4 Press [Close] to save settings or [Back] to cancel settings. The display returns to the Copy Default
screen.
Erasing Borders
Set the border erase default values. The setting ranges are as follows.
For further details about border erase, refer to page 1-19.
1 Referring to Accessing the Copy Default screen on page 7-2, access the Copy Default screen.
2 Press [S] or [T] to select Default erase width and press [Change #].
3 Press [+] or [–] to set the Border (outer edges) and Center (Centre) (middle) border widths.
4 Press [Close] to save settings or [Back] to cancel settings. The display returns to the Copy Default
screen.
Selecting Maximum Number of Copies
Limits the number of sets that can be specified for a single copy. Set to between 1 - 999 sets.
1 Referring to Accessing the Copy Default screen on page 7-2, access the Copy Default screen.
2 Press [S] or [T] to select Preset limit and press [Change #].
3 Use the numeric keys to specify the preset limit value.
4 Press [Close] to save settings or [Back] to cancel settings. The display returns to the Copy Default
screen.
Model Type Range
Inch models 0 - 3/4" (1/8" increments)
Metric models 0 - 18 mm (1 mm increments)
Model Type Range
Inch models 0 - 2" (1/8" increments)
Metric models 0 - 50 mm (1 mm increments)