TA Triumph-Adler DCC 2520 - Manual (Page 102)

Printer Settings
3-8
15 Press [S] or [T] to select Subnet Mask and press [Change #].
16 Set the address in the same manner as Steps 12 - 14 to set the IP address.
17 Press [S] or [T] to select Gateway and press [Change #].
18 Set the address in the same manner as Steps 12 - 14 to set the IP address.
19 Press [Close]. The display returns to the Interface Configuration screen.
20 Press [Close]. The display is returned to the Printer menu screen.
NetWare Setting
To connect via the Netware protocol, set to [On] and set frame mode to [Auto], [802.3], [Ethernet II],
[802.2] or [802.3SNAP].
1 Refer to steps 1 - 4 of TCP/IP Settings on page 3-6 to display the Interface screen.
2 Press [S] or [T] to select NetWare and
press [Change #].
3 Press [On] or [Off].
4 Press [Close]. The display returns to the Interface screen.
5 Press [Close]. The display is returned to the Printer menu screen.
EtherTalk Setting
Set EtherTalk to [On] to connect this device to an Apple Macintosh computer.
1 Refer to steps 1 - 4 of TCP/IP Settings on page 3-6 to display the Interface screen.
2 Press [S] or [T] to select Ethertalk and
press [Change #].
3 Press [On] or [Off].
4 Press [Close]. The display returns to the Interface screen.
5 Press [Close]. The display is returned to the Printer menu screen.
Interface
NetWare
Parallel Network
Change #
Setting Item Value
On
TCP/IP On
Ethertalk On
Network Status Page Off
USB
Printer menu
Interface
NetWare
Parallel Network
Change #
Setting Item Value
On
TCP/IP On
Ethertalk On
Network Status Page Off
USB
Printer menu