TA Triumph-Adler DCC 2520 - Manual (Page 273)

System Menu
7-25
Changing Management Code
Change the machine’s management code.
IMPORTANT: Be sure to record the management code when changing it. If forgotten, contact your
Service Representative.
NOTE: The default setting is 2500 for the 25/20 ppm model and 3200 for the 32/25 and 32/32 ppm
models.
Change the management code to a value between 0000 - 9999. Always set to 4 digits.
If the optional security kit has been installed, the management code is 8 digits long. The default
setting is 25002500 for the 25/20 ppm model and 32003200 for the 32/25 and 32/32 ppm models.
Change the management code to a value between 00000000 - 99999999. Always set to 8 digits.
It is recommended to not set the management code to an easily guessed number such as 11111111
or 12345678.
The following settings require the management code to be entered.
- Default Settings for Copying
- Machine Default
- Scanner Default Settings
- Auto Gray Adjust
- Color Registration
- Developer Refresh
- Printing Reports
- Setting Document Management Defaults
- Hard Disk Management
- Job Accounting
1 Referring to Accessing the Machine Default Screen on page 7-13, access the Machine Default
screen.
2 Press [S] or [T] to select Management code change (Change MGMT code with #) and press
[Change #].
3 Use the numeric keys to enter the new management code.
4 Press [Close] to save settings or [Back] to cancel settings. The display returns to the Machine
Default screen.