SMA SI 3.0-11 - Manual (Page 33)

SMA Solar Technology AG 6 Data Storage and Firmware Update
Operating Manual SI30M-44M-60H-80H-BE-en-30 33
6 Data Storage and Firmware Update
6.1 Inserting the SD Memory Card
Requirements:
☐ The SD memory card must be formatted as FAT-16 or FAT-32.
☐ The SD memory card must be used exclusively as a data medium for the system.
Procedure:
• Insert the SD memory card, with the slanted corner facing
upwards, into the SD memory card slot in the
Sunny Remote Control.
6.2 Saving and Loading Parameters
You can load and save the current parameter settings in two different parameter sets on the SD memory card. The two
parameter sets are distinguished by the Sunny Remote Control in Set1 and Set2. Each parameter set saves all settings.
This makes it possible to test the settings of a new parameter set without having to delete the old parameter set. Tip: As
soon as you have adjusted the system to your requirements, save the parameter settings to the SD memory card. After
saving, you can make further adjustments to the system. If the adjustment does not lead to the desired results, reload the
saved parameter set.
Requirement:
☐ The SD memory card must be inserted.
Procedure
1. Switch to installer mode on the Sunny Remote Control (see Section 5.4.1, page 29).
2. To save a parameter set, select the parameter 550.01 ParaSto and set the parameter:
3. Proceed as follows to load a parameter set:
• Switch to expert mode on the Sunny Remote Control (see Section 5.4.1, page 29).
• Select the parameter 550.02 ParaLod and set the parameter:
Value Explanation
Set1 Save the settings in the first parameter set.
Set2 Save the settings in the second parameter set.
Value Explanation
Set1 Loads the settings from the first parameter set.
Set2 Loads the settings from the second parameter set.
Factory Starts the quick configuration guide.