HEIDENHAIN TNC 320 (340 551-01) - Manual (Page 45)

HEIDENHAIN TNC 320 45
2.3 Spindle Speed S
, F
eed Rat
e
F and Miscellaneous F
u
nctions M
2.3 Spindle Speed S, Feed Rate F
and Miscellaneous Functions M
Function
In the Manual Operation and Electronic Handwheel operating modes,
you can enter the spindle speed S, feed rate F and the miscellaneous
functions M with soft keys. The miscellaneous functions are
described in Chapter 7 “Programming: Miscellaneous Functions.”
Entering values
Spindle speed S, miscellaneous function M
To enter the spindle speed, press the S soft key.
Enter the desired spindle speed and confirm your
entry with the machine START button.
The spindle speed S with the entered rpm is started with a
miscellaneous function M. Proceed in the same way to enter a
miscellaneous function M.
Feed rate F
After entering a feed rate F, you must confirm your entry with the OK
key instead of the machine START button.
The following is valid for feed rate F:
„ If you enter F=0, then the lowest feed rate from the machine
parameter minFeed is effective
„ If the feed rate entered exceeds the value defined in the machine
parameter maxFeed, then the parameter value is effective.
„
F is not lost during a power interruption
The machine tool builder determines which
miscellaneous functions M are available on your control
and what effects they have.
SPINDLE SPEED S =
1000