HEIDENHAIN TNC 320 (340 551-01) - Manual (Page 101)

HEIDENHAIN TNC 320 101
5.2 T
o
ol D
a
ta
TYPE Tool type: Press the SELECT TYPE (3rd soft-key row); the TNC
superimposes a window where you can select the type of tool
you want. Functions are currently only assigned to the DRILL and
MILL tool types. Tool type?
DOC Comment on tool (up to 16 characters) Tool description?
PLC Information on this tool that is to be sent to the PLC PLC status?
LCUTS Tooth length of the tool for Cycle 22 Tooth length in the tool axis?
ANGLE Maximum plunge angle of the tool for reciprocating plunge-cut in
Cycles 22 and 208 Maximum plunge angle?
CUT Number of teeth (20 teeth maximum) Number of teeth?
RTOL Permissible deviation from tool radius R for wear detection. If the
entered value is exceeded, the TNC locks the tool (status L). Input
range: 0 to 0.9999 mm Wear tolerance: radius?
LTOL Permissible deviation from tool length L for wear detection. If the
entered value is exceeded, the TNC locks the tool (status L). Input
range: 0 to 0.9999 mm Wear tolerance: length?
DIRECT. Cutting direction of the tool for measuring the tool during rotation Cutting direction (M3 = –)?
TT:R-OFFS Not supported at present Tool offset: radius?
TT:L-OFFS Not supported at present Tool offset: length?
LBREAK Permissible deviation from tool length L for breakage detection. If
the entered value is exceeded, the TNC locks the tool (status L).
Input range: 0 to 0.9999 mm Breakage tolerance: length?
RBREAK Permissible deviation from tool radius R for breakage detection. If
the entered value is exceeded, the TNC locks the tool (status L).
Input range: 0 to 0.9999 mm Breakage tolerance: radius?
LIFTOFF Definition of whether the TNC should retract the tool in the
direction of the positive tool axis at an NC stop in order to avoid
leaving dwell marks on the contour. If Y is defined, the TNC
retracts the tool from the contour by 0.1 mm, provided that this
function was activated in the NC program with M148 (see
“Automatically retract tool from the contour at an NC stop:
M148” on page 171). Retract tool Y/N ?
Abbr. Input Dialog