HEIDENHAIN TNC 320 (340 551-01) - Manual (Page 362)

362 10 Programming: Q Parameters
1
0
.1
1 Pr
eassigned Q
P
ar
amet
ers
Coordinates after probing during program run
The parameters Q115 to Q119 contain the coordinates of the spindle
position at the moment of contact during programmed measurement
with the 3-D touch probe. The coordinates are referenced to the
datum that is currently active in the Manual operating mode.
The length and radius of the probe tip are not compensated in these
coordinates.
Coordinate axis Parameter value
X axis Q115
Y axis Q116
Z axis Q117
IVth axis
Machine-dependent Q118
Vth axis
Machine-dependent Q119