HEIDENHAIN TNC 320 (340 551-01) - Manual (Page 337)

HEIDENHAIN TNC 320 337
1
0
.8 A
d
ditional F
u
nctions
54 - Direction of center misalignment with respect to spindle
0°
2 Center misalignment in minor axis
55 1 Rapid traverse
2 Probe feed rate
56 1 Maximum measuring range
2 Set-up clearance
57 1 Oriented spindle stop possible
0 = no, 1 = yes
2 Angle of spindle orientation in degrees
Reference point from touch
probe cycle, 360 1 1 to 9
(X, Y, Z, A, B, C,
U, V, W) Last reference point of a manual touch probe cycle, or last
touch point from Cycle without probe length
compensation but with probe radius compensation
(workpiece coordinate system)
2 1 to 9
(X, Y, Z, A, B, C,
U, V, W) Last reference point of a manual touch probe cycle, or last
touch point from Cycle 0 without probe length
compensation but with probe radius compensation
(machine coordinate system)
3 1 to 9
(X, Y, Z, A, B, C,
U, V, W) Result of measurement of the touch probe cycles 0 and 1
without touch probe radius and probe length
compensation
4 1 to 9
(X, Y, Z, A, B, C,
U, V, W) Last reference point of a manual touch probe cycle, or last
touch point from Cycle 0 without probe length
compensation but with probe radius compensation
(workpiece coordinate system)
10 - Oriented spindle stop
Value from the active datum table
in the active coordinate system,
500 Line Column Read values
Read data of the current tool, 950 1 - Tool length L
2 - Tool radius R
3 - Tool radius R2
4 - Oversize for tool length DL
5 - Oversize for tool radius DR
6 - Oversize for tool radius DR2
7 - Tool locked TL:
0 = not locked, 1 = locked
Group name, ID No. Number Index Meaning