HEIDENHAIN TNC 320 (340 551-01) - Manual (Page 380)

380 11 Test Run and Program Run
1
1
.1 Gr
aphics
Magnifying details
You can magnify details in the Test Run and a program run operating
modes and in the projection in 3 planes and the 3-D display modes.
The graphic simulation or the program run, respectively, must first
have been stopped. A detail magnification is always effective in all
display modes.
Changing the detail magnification
The soft keys are listed in the table.
8 Interrupt the graphic simulation, if necessary.
8 Shift the soft-key row in the Test Run mode, or in a program run
mode, respectively, until the soft key for detail enlargement
appears.
8 Select the functions for section magnification.
8 Press the corresponding soft key to select the
workpiece surface (see table below).
8 To reduce or magnify the blank form, press and hold
the ZOOM IN or ZOOM OUT soft keys.
8 Shift the soft-key row and select the TRANSFER
DETAIL soft key
8 Restart the test run or program run by pressing the
START soft key (RESET + START returns the
workpiece blank to its original state).
Coordinates for magnifying details
The TNC displays the selected workpiece side for each axis and the
coordinates of the remaining form during a detail magnification.
Function Soft keys
Select the left/right workpiece surface
Select the front/back workpiece surface
Select the top/bottom workpiece surface
Shift the sectional plane to reduce or
magnify the blank form
Select the isolated detail
After a new workpiece detail magnification is selected, the
control “forgets” previously simulated machining
operations. The TNC then displays machined areas as
unmachined areas.