HEIDENHAIN TNC 320 (340 551-01) - Manual (Page 285)

HEIDENHAIN TNC 320 285
8.7 Coor
dinat
e
T
ransf
or
mation Cy
cles
Configuring the datum table
If you do not wish to define a datum table for an active axis, press the
DEL key. Then the TNC clears the numerical value from the
corresponding input field?
To leave a datum table
Select a different type of file in file management and choose the
desired file.
Status displays
The additional status display shows the values of the active datum
shift.
|’FF˜‰ pp=am"›F˜›"m’Oph"›apm’Š˜pm˜z"VF˜–}:
After you have changed a value in a datum table, you must
save the change with the ENT key. Otherwise the change
may not be included during program run.