HEIDENHAIN TNC 320 (340 551-01) - Manual (Page 432)

432 13 Touch Probe Cycles in the Manual and Electronic Handwheel Modes
13.7 A
u
to
matic W
o
rk
piece Measur
ement
DATUM PLANE touch probe cycle 1
Touch probe cycle 1 measures any position on the workpiece in any
direction.
1 The touch probe moves at rapid traverse to the starting position 1
programmed in the cycle.
2 Then the touch probe approaches the workpiece at the assigned
feed rate. During probing the TNC moves simultaneously in 2 axes
(depending on the probing angle). The scanning direction is defined
by the polar angle entered in the cycle.
3 After the TNC has saved the position, the probe returns to the
starting point. The TNC also stores the coordinates of the touch
probe position at the time of the triggering signal in parameters
Q115 to Q119.
8 Probing axis: Enter the probing axis with the axis
selection keys or ASCII keyboard. Confirm your entry
with the ENT key.
8 Probing angle: Angle, measured from the probing
axis, at which the touch probe is to move.
8 Position value: Use the axis selection keys or the
ASCII keyboard to enter all coordinates of the nominal
pre-positioning point values for the touch probe.
8 To conclude the input, press the ENT key.
X
Y
1
Before programming, note the following:
Pre-position the touch probe in order to avoid a collision
when the programmed pre-positioning point is
approached.
Example: NC blocks
67 TCH PROBE 1.0 POLAR DATUM PLANE
68 TCH PROBE 1.1 X ANGLE: +30
69 TCH PROBE 1.2 X+5 Y+0 Z-5