H3C Technologies H3C S7500E Series Switches - Manual (Page 83)

3-19
To do… Use the command… Remarks
Configure an NTP
authentication key
ntp-service
authentication-keyid keyid
authentication-mode md5
value
Required
No NTP authentication key by
default
Configure the key as a trusted
key
ntp-service reliable
authentication-keyid keyid
Required
No authentication key is
configured to be trusted by
default.
Enter interface view
interface interface-type
interface-number
—
Broadcast server mode:
ntp-service broadcast-server
authentication-keyid keyid
Associate the specified key with
an NTP server
Multicast server mode:
ntp-service multicast-server
authentication-keyid keyid
Required
You can associate a
non-existing key with an NTP
server. To enable NTP
authentication, you must
configure the key and specify it
as a trusted key after
associating the key with the
NTP server.
The procedure of configuring NTP authentication on a server is the same as that on a client,
and the same authentication key must be configured on both the server and client sides.
Displaying and Maintaining NTP
To do… Use the command… Remarks
View the information of NTP
service status
display ntp-service status Available in any view
View the information of NTP
sessions
display ntp-service sessions
[ verbose ]
Available in any view
View the brief information of the
NTP servers from the local
device back to the primary
reference source
display ntp-service trace Available in any view