H3C Technologies H3C S7500E Series Switches - Manual (Page 156)

9-9
To do… Use the command… Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Configure the current port as a
mirroring port
[ mirroring-group group-id ]
mirroring-port { both | inbound |
outbound }
Required
By default, a port does not serve
as a mirroring port for any
mirroring group.
z A mirroring group can contain multiple mirroring ports.
z To ensure that the port mirroring function works properly, do not assign a mirroring port to the
remote probe VLAN.
Configuring the egress port for the remote source mirroring group
You can configure the egress port for a mirroring group in system view, or assign the current port to it
as the egress port in interface view. The two configuration modes lead to the same result.
z Configuring the egress port in system view
Follow these steps to configure the egress port for the remote source mirroring group in system view:
To do… Use the command… Remarks
Enter system view system-view —
Configure the egress port for the
remote source mirroring group
mirroring-group group-id
monitor-egress
monitor-egress-port
Required
By default, no egress port is
configured for a mirroring group.
z Configuring the egress port in interface view
Follow these steps to configure the egress port for the remote source mirroring group in interface view:
To do… Use the command… Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Configure the current port as the
egress port
mirroring-group group-id
monitor-egress
Required
By default, a port does not serve
as the egress port for any mirroring
group.