H3C Technologies H3C S7500E Series Switches - Manual (Page 35)

2-15
Configuration prerequisites
The SNMP agent function must be enabled on the device that serves as an SNMP agent before an
SNMP test. For the configuration of SNMP agent, see SNMP Configuration in the Network
Management and Monitoring Configuration Guide.
Configuring an SNMP test
Follow these steps to configure an SNMP test:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as SNMP
and enter test type view
type snmp Required
Configure the destination address
for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
Specify the source port number for
a probe request in a test operation
source port port-number
Optional
By default, no source port number
is specified.
Configure the source IP address of
a probe request in a test operation
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be
that of an interface on the device
and the interface must be up.
Otherwise, the test will fail.
Configure common optional
parameters
See Configuring Optional
Parameters Common to an NQA
Test Group
Optional
Configuring a TCP Test
A TCP test is used to test the TCP connection between the client and the specified port on the NQA
server and the setup time for the connection, thus judging the availability and performance of the
services provided on the specified port on the server.
Configuration prerequisites
A TCP test requires cooperation between the NQA server and the NQA client. Configure the TCP
listening function on the NQA server before the TCP test. For the configuration of the TCP listening
function, see Configuring the NQA Server .