H3C Technologies H3C S7500E Series Switches - Manual (Page 36)

2-16
Configuring a TCP test
Follow these steps to configure a TCP test:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as TCP
and enter test type view
type tcp Required
Configure the destination address
for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
The destination address must be
the IP address of the listening
service configured on the NQA
server.
Configure the destination port destination port port-number
Required
By default, no destination port
number is configured for a test
operation.
The destination port number must
be consistent with port number of
the listening service configured on
the NQA server.
Configure the source IP address of
a probe request in a test operation
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be
that of an interface on the device
and the interface must be up.
Otherwise, the test will fail.
Configure common optional
parameters
See Configuring Optional
Parameters Common to an NQA
Test Group
Optional
Configuring a UDP Echo Test
A UDP echo test is used to test the connectivity and round-trip time of a UDP echo packet from the
client to the specified UDP port on the NQA server.