H3C Technologies H3C S7500E Series Switches - Manual (Page 82)

3-18
To do… Use the command… Remarks
Enter system view system-view —
Enable NTP authentication
ntp-service authentication
enable
Required
Disabled by default
Configure an NTP
authentication key
ntp-service
authentication-keyid keyid
authentication-mode md5
value
Required
No NTP authentication key by
default
Configure the key as a trusted
key
ntp-service reliable
authentication-keyid keyid
Required
No authentication key is
configured to be trusted by
default.
Client/server mode:
ntp-service unicast-server
{ ip-address | server-name }
authentication-keyid keyid
Associate the specified key with
an NTP server
Symmetric peers mode:
ntp-service unicast-peer
{ ip-address | peer-name }
authentication-keyid keyid
Required
You can associate a
non-existing key with an NTP
server. To enable NTP
authentication, you must
configure the key and specify it
as a trusted key after
associating the key with the
NTP server.
After you enable the NTP authentication feature for the client, make sure that you configure for
the client an authentication key that is the same as on the server and specify that the
authentication key is trusted; otherwise, the client cannot be synchronized to the server.
Configuring NTP authentication for a server
Follow these steps to configure NTP authentication for a server:
To do… Use the command… Remarks
Enter system view system-view —
Enable NTP authentication
ntp-service authentication
enable
Required
Disabled by default