H3C Technologies H3C S7500E Series Switches - Manual (Page 26)

2-6
Creating an NQA Test Group
One test corresponds to one test group. You can configure test types after you create a test group and
enter the test group view.
Follow theses steps to create an NQA test group:
To do… Use the command… Remarks
Enter system view system-view —
Create an NQA test group and
enter the NQA test group view
nqa entry admin-name
operation-tag
Required
If you execute the nqa entry command to enter the test group view with test type configured, you
directly enter the test type view of the test group.
Configuring an NQA Test Group
Configuring an ICMP Echo Test
An ICMP echo test is used to test reachability of the destination host according to the ICMP echo reply
or timeout information. An ICMP echo test has the same function as the ping command but provides
more output information. It enables you to locate connectivity problems in a network.
Follow these steps to configure an ICMP echo test:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as ICMP
echo and enter test type view
type icmp-echo Required
Configure the destination address
for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
Configure the size of probe
packets sent
data-size size
Optional
100 bytes by default.