H3C Technologies H3C S7500E Series Switches - Manual (Page 25)

2-5
Task Remarks
Configuring a DLSw Test
Configuring the Collaboration Function Optional
Configuring Trap Delivery Optional
Configuring the NQA Statistics Function Optional
Configuring the History Records Saving Function Optional
Configuring Optional Parameters Common to an NQA Test Group Optional
Scheduling an NQA Test Group Required
Configuring the NQA Server
Before performing TCP, UDP echo, UDP jitter, or voice tests, configure the NQA server on the peer
device. The NQA server makes a response to the request sent by the NQA client by listening to the
specified destination address and port number.
Follow these steps to configure the NQA server:
To do… Use the command… Remarks
Enter system view system-view —
Enable the NQA server nqa server enable
Required
Disabled by default.
Configure the listening service on
the NQA server
nqa server { tcp-connect |
udp-echo } ip-address
port-number
Required
The IP address and port number
must be consistent with those
configured on the NQA client and
must be different from those of an
existing listening service.
Enabling the NQA Client
Configurations on the NQA client take effect only when the NQA client is enabled.
Follow these steps to enable the NQA client:
To do… Use the command… Remarks
Enter system view system-view —
Enable the NQA client nqa agent enable
Optional
Enabled by default.