H3C Technologies H3C S7500E Series Switches - Manual (Page 155)

9-8
Configuration Prerequisites
Before configuring Layer 2 remote port mirroring, make sure that you have created static VLANs for
the remote probe VLAN.
The remote source mirroring group on the source device and the remote destination mirroring group
on the destination device must use the same remote probe VLAN.
Configuring a Remote Source Mirroring Group (on the Source Device)
To configure a remote source mirroring group, make the following configurations on the source device:
Creating a remote source mirroring group
Follow these steps to create a remote source mirroring group:
To do… Use the command… Remarks
Enter system view system-view —
Create a remote source
mirroring group
mirroring-group group-id
remote-source
Required
By default, no mirroring group
exists on a device.
Configuring mirroring ports for the remote source mirroring group
You can configure a list of mirroring ports for a mirroring group at a time in system view, or assign only
the current port to it as a mirroring port in interface view. To assign multiple ports to the mirroring group
as mirroring ports in interface view, repeat the step.
z Configuring mirroring ports in system view
Follow these steps to configure mirroring ports for the remote source mirroring group in system view:
To do… Use the command… Remarks
Enter system view system-view —
Configure mirroring ports for the
remote source mirroring group
mirroring-group group-id
mirroring-port mirroring-port-list
{ both | inbound | outbound }
Required
By default, no mirroring port is
configured for a mirroring group.
z Configuring a mirroring port in interface view
Follow these steps to configure a mirroring port for the remote source mirroring group in interface
view: