H3C Technologies H3C S7500E Series Switches - Manual (Page 186)

12-4
Information
channel
number
Default
channel name
Default output destination Description
3 trapbuffer Trap buffer
Receives trap information, a buffer
inside the router for recording
information.
4 logbuffer Log buffer
Receives log and debugging
information, a buffer inside the
router for recording information.
5 snmpagent SNMP module Receives trap information.
6 channel6 Not specified
Receives log, trap, and debugging
information.
7 channel7 Not specified
Receives log, trap, and debugging
information.
8 channel8 Not specified
Receives log, trap, and debugging
information.
9 channel9 Log file
Receives log, trap, and debugging
information.
Configurations for the seven output destinations function independently and take effect only
after the information center is enabled.
Outputting System Information by Source Module
The system is composed of a variety of protocol modules, board drivers, and configuration
modules. The system information can be classified, filtered, and output according to source
modules. You can use the info-center source ? command to view the supported information
source modules.
Default Output Rules of System Information
The default output rules define the source modules allowed to output information on each
output destination, the output information type, and the output information level as shown in
Table 12-3 , which indicates that by default and in terms of all modules:
z All log information is allowed to be output to the log file; log information with severity level
equal to or higher than informational is allowed to be output to the log host; log information
with severity level equal to or higher than warning is allowed to be output to the console,