Level (severity), Digest, Source – H3C Technologies H3C S7500E Series Switches User Manual
Page 189: Content, Configuring information center, Information center configuration task list
12-7
level (severity)
System information can be divided into eight levels based on its severity, from 0 to 7. Refer to
for definition and description of these severity levels. The levels of system
information generated by modules are predefined by developers, and you cannot change the
system information levels. However, you can configure to output information of the specified
level using the info-center source command.
digest
The digest field is a string of up to 32 characters, outlining the system information.
For system information destined to the log host:
z
If the character string ends with (l), the information is log information
z
If the character string ends with (t), the information is trap information
z
If the character string ends with (d), the information is debugging information
For system information destined to other destinations:
z
If the timestamp starts with a %, the information is log information
z
If the timestamp starts with a #, the information is trap information
z
If the timestamp starts with a *, the information is debugging information
source
This field indicates the source of the information, such as the slot number of a board, IRF
member ID, IRF member ID and slot number, or the source IP address of the log sender. This
field is optional and is displayed only when the output destination is the log host.
content
This field provides the content of the system information.
Configuring Information Center
Information Center Configuration Task List
Complete the following tasks to configure information center:
Task
Remarks
Outputting System Information to the Console
Optional
Outputting System Information to a Monitor Terminal
Optional
Outputting System Information to a Log Host
Optional
Outputting System Information to the Trap Buffer
Optional
Outputting System Information to the Log Buffer
Optional
Outputting System Information to the SNMP Module
Optional
Saving System Information to a Log File
Optional
Configuring Synchronous Information Output
Optional