H3C Technologies H3C S7500E Series Switches - Manual (Page 31)

2-11
z When you execute the put command, a file file-name with fixed size and content is created on the
FTP server. When you execute the get command, the device does not save the files obtained
from the FTP server.
z When you execute the get command, the FTP test cannot succeed if a file named file-name does
not exist on the FTP server.
z When you execute the get command, use a file with a smaller size because a big file may result in
test failure due to timeout, or may affect other services because of occupying too much network
bandwidth.
Configuring an HTTP Test
An HTTP test is used to test the connection between the NQA client and a specified HTTP server and
the time required to obtain data from the HTTP server, thus detecting the connectivity and
performance of the HTTP server.
Configuration prerequisites
Before performing an HTTP test, configure the HTTP server.
Configuring an HTTP test
Follow these steps to configure an HTTP test:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as HTTP
and enter test type view
type http Required
Configure the destination address
for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
The destination IP address for a
test operation is the IP address of
the HTTP server.