H3C Technologies H3C S7500E Series Switches - Manual (Page 195)

12-13
Outputting System Information to the Log Buffer
You can configure to output log, trap, and debugging information to the log buffer, but the log
buffer receives the log and debugging information only, and discards the trap information.
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default.
Name the channel with a
specified channel number
info-center channel
channel-number name
channel-name
Optional
Refer to Table 12-2 for default
channel names.
Configure the channel through
which system information can
be output to the log buffer and
specify the buffer size
info-center logbuffer [ channel
{ channel-number |
channel-name } | size
buffersize ] *
Optional
By default, system information is
output to the log buffer through
channel 4 (known as logbuffer)
and the default buffer size is
512.
Configure the output rules of the
system information
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log
{ level severity | state state } * |
trap { level severity | state
state } * ] *
Optional
Refer to Default Output Rules of
System Information.
Configure the format of the
timestamp
info-center timestamp
{ debugging | log | trap } { boot
| date | none }
Optional
The time stamp format for log,
trap and debugging information
is date by default.