H3C Technologies H3C S7500E Series Switches - Manual (Page 159)

9-12
To do… Use the command… Remarks
Enter system view system-view —
Configure the remote probe VLAN
mirroring-group group-id
remote-probe vlan rprobe-vlan-id
Required
By default, no remote probe VLAN
is configured for a mirroring group.
z You are recommended to use the remote probe VLAN for port mirroring exclusively.
z To remove the VLAN configured as a remote probe VLAN, you must remove the remote probe
VLAN with undo mirroring-group remote-probe vlan command first. Removing the probe
VLAN can invalidate the remote source mirroring group.
Assigning the monitor port to the remote probe VLAN
Follow these steps to assign the monitor port to the remote probe VLAN:
To do… Use the command… Remarks
Enter system view system-view —
Enter the interface view of the
monitor port
interface interface-type interface-number —
For an access
port
port access vlan vlan-id
For a trunk port port trunk permit vlan vlan-id
Assign the
port to the
probe VLAN
For a hybrid port port hybrid vlan vlan-id { tagged | untagged }
Required
Use one of the
commands
For more information about the port access vlan command, the port trunk permit vlan command,
and the port hybrid vlan command, see VLAN Configuration Commands in the Layer 2 - LAN
Switching Command Reference.