H3C Technologies H3C S7500E Series Switches - Manual (Page 169)

9-22
# Configure GigabitEthernet 2/0/1 as a mirroring port and GigabitEthernet 2/0/2 as the monitor port of
local mirroring group 1.
[DeviceC] mirroring-group 1 mirroring-port gigabitethernet 2/0/1 inbound
[DeviceC] mirroring-group 1 monitor-port gigabitethernet 2/0/2
5) Verify the configurations
After the above configurations are completed, you can monitor all the packets received and sent by
the marketing department on the server.
Local Port Mirroring Configuration Example for ONUs
Network requirements
As shown in Figure 9-7 , the customer network is as described below:
z OLT 3/0/1 of Device A (an S7500E switch) is connected to ONU 3/0/1:1 of an ONU. The ONU is
connected to hosts and a server (a data monitoring device).
z Host A, Host B, and Server are connected to UNI 1, UNI 2, and UNI 3 of the ONU respectively.
z On Device, remotely configure local port mirroring for the ONU to mirror the traffic received on
UNI 1 to UNI 3, so that Server can collect all traffic sent by Host A.
Figure 9-7 Network diagram for local port mirroring configuration
ONU
Device A
Olt3/0/1
Server
POS
UNI 1 UNI 2
UNI 3
HostA HostB
Configuration procedure
# Enter system view.
system-view
# Enter ONU port view.
[DeviceA] interface Onu 3/0/1:1
# Configure UNI 1 as the mirroring port for local port mirroring and specify to mirror traffic received on
UNI 1.
[DeviceA-Onu3/0/1:1] uni 1 mirroring-port inbound
# Configure UNI 3 as the monitor port for local port mirroring.
[DeviceA-Onu3/0/1:1] uni 3 monitor-port
After the above configurations are completed, you can monitor all the packets sent by Host A on the
server.