H3C Technologies H3C S7500E Series Switches - Manual (Page 132)

6-14
For the configurations for the NMS and agent, see SNMPv1/SNMPv2c Configuration Example
and SNMPv3 Configuration Example .
# Enable logging display on the terminal. (This function is enabled by default, so that you can
omit this configuration).
terminal monitor
terminal logging
# Enable the information center to output the system information with the severity level equal to
or higher than informational to the console port.
system-view
[Sysname] info-center source snmp channel console log level informational
# Enable SNMP logging on the agent to log the GET and SET operations of the NMS.
[Sysname] snmp-agent log get-operation
[Sysname] snmp-agent log set-operation
z The following log information is displayed on the terminal when the NMS performs the Get
operation to the agent.
%Jan 1 02:49:40:566 2006 Sysname SNMP/6/GET:
seqNO = <10> srcIP = <1.1.1.2> op = node = value=<>
z The following log information is displayed on the terminal when the NMS performs the Set
operation to the agent.
%Jan 1 02:59:42:576 2006 Sysname SNMP/6/SET:
seqNO = <11> srcIP = <1.1.1.2> op = errorIndex = <0> errorStatus = node
= value =
Table 6-1 Description on the output field of SNMP log
Field Description
Jan 1 02:49:40:566 2006 The time when the SNMP log is generated
seqNO
Serial number of the SNMP log (The system numbers the
recorded SNMP logs automatically; the serial number
starts from 0)
srcIP IP address of the NMS
op SNMP operation type (GET or SET)
node
Node name of the SNMP operations and OID of the
instance
erroIndex Error index, with 0 meaning no error
errorstatus Error status, with noError meaning no error