H3C Technologies H3C S7500E Series Switches - Manual (Page 193)

12-11
To do… Use the command… Remarks
Specify a log host and configure
the parameters when system
information is output to the log
host
info-center loghost host-ip
[ port port-number ] [ channel
{ channel-number |
channel-name } | facility
local-number ] *
Required
By default, the system does not
output information to a log host.
If you specify to output system
information to a log host, the
system uses channel 2 (loghost)
by default.
The value of the port-number
argument should be the same
as the value configured on the
log host, otherwise, the log host
cannot receive system
information.
Configure the output rules of the
system information
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log
{ level severity | state state } * |
trap { level severity | state
state } * ] *
Optional
Refer to Default Output Rules of
System Information .
Specify the source IP address
for the log information
info-center loghost source
interface-type interface-number
Optional
By default, the source interface
is determined by the matched
route, and the primary IP
address of this interface is the
source IP address of the log
information.
Configure the format of the time
stamp for system information
output to the log host
info-center timestamp loghost
{ date | no-year-date | none }
Optional
date by default.
Outputting System Information to the Trap Buffer