Snmp logging configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S7500E Series Switches User Manual
Page 131
6-13
SNMPv3 uses an authentication and privacy security model. On the NMS, the user needs to
specify the username and security level, and based on that level, configure the authentication
mode, authentication password, privacy mode, and privacy password. In addition, the timeout
time and number of retries should also be configured. The user can inquire and configure the
device through the NMS.
The configurations on the agent and the NMS must match.
3) Verify
the
configuration
z
After the above configuration, an SNMP connection is established between the NMS and
the agent. The NMS can get and configure the values of some parameters on the agent
through MIB nodes.
z
Execute the shutdown or undo shutdown command to an idle interface on the agent, and
the NMS receives the corresponding trap.
SNMP Logging Configuration Example
Network requirements
z
As shown in
, the NMS and the agent are connected through an Ethernet.
z
The IP address of the NMS is 1.1.1.2/24
z
The IP address of the agent is 1.1.1.1/24
z
Configure SNMP logging on the agent to record the operations performed by the NMS to
the agent
Figure 6-5 Network diagram for SNMP logging
Configuration procedure