H3C Technologies H3C S7500E Series Switches - Manual (Page 196)

12-14
Outputting System Information to the SNMP Module
The SNMP module receives the trap information only, and discards the log and debugging
information even if you have configured to output them to the SNMP module.
To monitor the device running status, trap information is usually sent to the SNMP network
management station (NMS). In this case, you need to configure to send traps to the SNMP
module, and then set the trap sending parameters for the SNMP module to further process
traps. For details, refer to SNMP Configuration in the Network Management and Monitoring
Configuration Guide.
Follow these steps to configure to output system information to the SNMP module:
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default
Name the channel with a
specified channel number
info-center channel
channel-number name
channel-name
Optional
Refer to Table 12-2 for default
channel names.
Configure the channel through
which system information can
be output to the SNMP module
info-center snmp channel
{ channel-number |
channel-name }
Optional
By default, system information is
output to the SNMP module
through channel 5 (known as
snmpagent).
Configure the output rules of the
system information
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log
{ level severity | state state } * |
trap { level severity | state
state } * ] *
Optional
Refer to Default Output Rules of
System Information.
Configure the format of the
timestamp
info-center timestamp
{ debugging | log | trap } { boot
| date | none }
Optional
The time stamp format for log,
trap and debugging information
is date by default.