Notes to cnc interface cable run list – Hypertherm HPR260 Manual Gas Preventive Maintenance Program Rev.5 User Manual

Page 74

INSTALLATION

HPR260 Auto Gas

Instruction Manual

3-25

Caution: The CNC cable must be constructed using cable with 360-degree shield and

metal housing connectors at each end. The shield must be terminated to the
metal housings at each end to ensure proper grounding and to provide the
best shield.

Notes to CNC interface cable run list

Note 1. I

nputs are optically isolated. They require 24 VDC at 7.3 mA, or dry-contact closure.

The external relay’s life

may be improved by adding a metallized-polyester capacitor (0.022µF 100V or higher) in parallel with the
relay contacts

Note 2.

Outputs are optically isolated, open collector, transistors. The maximum rating is 24 VDC at 10 mA.

Note 3. Machine motion is selectable and is used for configurations with multiple plasma systems.

Note 4.

CNC +24 VDC provides 24 VDC at 200 mA maximum. A jumper is required on J304 to use 24 V power.

This manual is related to the following products:

HyPerformance HPR130 Auto Gas THC X-Y Table Torch Height Control HyPerformance HPR130 Manual Gas HD4070 Rev.1 HPR260 Auto Gas Preventive Maintenance Program Rev.4 Powermax1650