Hypertherm HPR260 Manual Gas Preventive Maintenance Program Rev.5 - Manual (Page 182)

MAINTENANCE
5-38 HPR260 Auto Gas Instruction Manual
Power supply control board PCB3
Control PC Board LEDN300 List
LEDN Output Input Notes
L EDN1 Machine motion
LEDN2 Error
LEDN3 Ramp-down error
LEDN4 Not ready
LEDN5 Soft-start enable Not used
LEDN6 Pilot arc enable
LEDN7 Corner current
LEDN8 Pierce
LEDN9 Hold
L EDN10 Plasma start
Control PC board LED list
LED Signal Notes
D100 +5 VDC
D101 +3.3 VDC
D113 CAN TX Constant blinking
D114 CAN RX Constant blinking
Control PC Board LEDN301 List
LEDN Output Input Notes
L EDN1 HV transformer
LEDN2 Pump motor enable
LEDN3 Contactor
LEDN4 Pilot arc relay
LEDN5 Spare
LEDN6 Surge select
LEDN7 Not connected
LEDN8 Not connected
LEDN9 Not connected
L EDN10 Phase loss
Control PCB3 firmware list
Item Part number
U104 081107 EVEN
U105 081107 ODD
= HPR130
= HPR260
Note: see wiring
diagrams for
other dipswitch
settings
Caution: Revision “J” software, or later, is required for the safe operation of
the automatic gas console.
5