Hypertherm HPR260 Manual Gas Preventive Maintenance Program Rev.5 - Manual (Page 106)

OPERATION
4-12 HPR260 Auto Gas Instruction Manual
5
Cut charts
The following Cut charts show the consumable parts, cutting speeds and the gas and torch settings required for each
process.
The numbers shown in the Cut charts are recommended to provide high-quality cuts with minimal dross. Because of
differences between installations and material composition, adjustments may be required to obtain desired results.
Bevel cutting
See Appendix C in this manual for cut charts and consumables.
Marking
Any of the consumable sets can also be used for marking. Marking parameters are shown at the bottom of each cut
chart. The quality of the markings will vary depending on the cut process, material type, and material thickness
combination. Marking is not possible for every combination (very thin materials). Poor quality marking or burn-through
may occur with material less than 1.5 mm (0.060 in or 16 gauge).
Consumables for mirror-image cutting
See the Parts List section in this manual for part numbers.