Hypertherm HPR260 Manual Gas Preventive Maintenance Program Rev.5 - Manual (Page 266)

APPENDIX B – CNC INTERFACE PROTOCOL
HPR260 Auto Gas Instruction Manual b-21
5
ID Name Description
072
AUTOMATIC GAS CONTROL BOARD
OVERTEMP
Control board has exceeded 90° C (194° F).
093 NO COOLANT FLOW Coolant flow is less than 0.6 gpm.
099 CHOPPER1 OVERTEMP AT INIT Chopper #1 is indicating overtemp during power-up.
100 CHOPPER2 OVERTEMP AT INIT Chopper #2 is indicating overtemp during power-up.
101 MAGNETICS OVERTEMP AT INIT Transformer is indicating overtemp during power-up.
102 OUTPUT CURRRENT AT INIT Chopper current signal is active on power-up.
103 CURRENT TOO HIGH ON LEM #1
A current greater than 35 amps has been detected by current
sensor 1.
104 CURRENT TOO HIGH ON LEM #2
A current greater than 35 amps has been detected by current
sensor 2.
105 CURRENT TOO LOW ON LEM #1
A current less than 10 amps has been detected by current
sensor 1.
106 CURRENT TOO LOW ON LEM #2
A current less than 10 amps has been detected by current
sensor 2.
108 TRANSFER AT INIT
The system has detected current on the work lead during
power-up.
109 COOLANT FLOW AT INIT
Coolant flow is greater than 1.14 lpm (0.3 gpm) when pump is
off.
111 COOLANT OVERTEMP AT INIT Coolant is indicating overtemp during power-up.
116 WATCHDOG INTERLOCK CAN communication error.
123 MV 1 ERROR Motor valve 1 did not move into position within 60 seconds.
124 MV 2 ERROR Motor valve 2 did not move into position within 60 seconds.
133 UNKNOWN GAS CONSOLE TYPE
The power supply control board does not recognize the gas
console installed or has not received a CAN message identifying
the type of console installed.
134 CHOPPER 1 OVERCURRENT Chopper 1 current feedback has exceeded 160 amps.
138 CHOPPER 2 OVERCURRENT Chopper 2 current feedback has exceeded 160 amps.
139 PURGE TIMEOUT ERROR The purge cycle did not complete within 3 minutes.
140
AUTO GAS PRESSURE TRANSDUCER
#1 ERROR
Faulty transducer or auto gas control PCB
141
AUTO GAS PRESSURE TRANSDUCER
#2 ERROR
Faulty transducer or auto gas control PCB
142
AUTO GAS PRESSURE TRANSDUCER
#3 ERROR
Faulty transducer or auto gas control PCB
143
AUTO GAS PRESSURE TRANSDUCER
#4 ERROR
Faulty transducer or auto gas control PCB
144
MANUAL GAS CONSOLE INTERNAL
FLASH MEMORY ERROR
Replace manual gas console control PCB
145
AUTOMATIC GAS CONSOLE INTERNAL
FLASH MEMORY ERROR
Replace auto gas console control PCB
151 SOFTWARE FAIL Software has detected an incorrect state or condition.
152 INTERNAL FLASH ERROR DSP memory is not working properly.
153 PS EEPROM ERROR EEPROM memory on power supply board not working.
180 SELECTION CONSOLE CAN TIMEOUT
Power supply has not received a CAN message from the
selection console within 1 second
181 METERING CONSOLE CAN TIMEOUT
Power supply has not received a CAN message from the
metering console within 1 second