Hypertherm HPR260 Manual Gas Preventive Maintenance Program Rev.5 - Manual (Page 251)

APPENDIX B – CNC INTERFACE PROTOCOL
b-6 HPR260 Auto Gas Instruction Manual
Command table (1 of 13)
ID Command System Description
000 HELLO Manual gas system
Auto gas system Establish communications with the plasma system. Use this command
to identify which system you are talking to.
Data:
None
Return value:
String identifying the system
Sample:
>00090<
>000HYPERFORMANCE130MANUALB5<
or
>000HYPERFORMANCE130AUTO30<
or
>000HYPERFORMANCE130AUTOMIX1E<
001 VERSION Manual gas system
Auto gas system Get the version of the power supply firmware
Data:
None
Return value:
Power supply firmware then Gas console firmware, space-delimited
Sample:
>00191<
>001A.0 A.25<
(power suppy rev A, gas rev A)
002 GET_STATE Manual gas system
Auto gas system Get the current state of the plasma system.
Data:
None
Return value:
Status code (see table V)
Sample:
>00292<
>002000052< (status code 0)
003 LAST_ERROR Manual gas system
Auto gas system Get the last error that occurred at the system.
Data:
None
Return value:
Error code (see table IV)
Sample:
>00393<
>00301165B< (error code 116)
004 REMOTE_MODE Manual gas system
Auto gas system Switch system into remote mode, to allow remote control of the plasma
system.
Data:
None
Return value:
1 = accepted, 0 = not accepted
Sample:
>00494<
>0041C5<
5