ETA Duplica Vital - Manual (Page 54)

A) For all PREHEAT / KNEAD 1,2,3 / RISE 1,2 / BAKE 1,2 / KEEP WARM, the procedure
for time programming is as follows:
- Press CYKLUS (CYCLE) button to display PREHEAT and time programmed for this work
cycle
OFF
on the display (time data will be permanently displayed on the display).
- Press ČAS (TIME) button to setup the cycle duration (see table) or the phase may be
removed from the program (if you enter OFF), (time code flashes on the display).
- Press CYKLUS (CYCLE) button to move to the next phase of programming.
For programming of RISE 1, 2 phase, proceed according to section B.
For programming of BAKE 1, 2 phase, proceed according to section C.
B) For all phases RISE 1, 2 you can also set internal temperature of the bread maker from
20 to 50 °C in 2 °C increments in addition to time. To set the required temperature:
- Press ČAS (TIME) button to set the cycle time (time flashes on the display).
- Press BARVA (COLOUR) button (°30 displays on the display).
- Press ČAS (TIME) button to set required temperature.
- Then, press CYKLUS (CYCLE) to confirm and to move to the next programming phase.
C) For all phases BAKE 1, 2 you can also set crust colour in five increments (LL / L / M / D
/ DD) in addition to time. Required crust colour is set as follows:
- Press ČAS (TIME) button to set the cycle time (time flashes on the display).
- Press BARVA (COLOUR) button to set required crust colour.
- Then, press CYKLUS (CYCLE) to confirm and to move to the next programming phase.
Following setup of all phases press START/STOP button and preparation time
(e.g. 1:50) will display on the display; press START/STOP one more time and the set
program will start (the colon starts flickering).
PREHEAT KNEAD 1 KNEAD 2 RISE 1 KNEAD 3 RISE 2 BAKE 1 BAKE 2 KEEP
Preparation phase WARM
Time scope setting (min.) 0 - 30 0 - 30 0 - 5 - 20 0 - 360 0 - 5 0 - 360 0 - 120 0 - 120 0 - 60
Preset (min.) 0FF 0FF 0FF 0FF 0FF 0FF 60 0FF 0FF
Temperature scope setting (°C) - - - 20 - 50 - 20 - 50 - - -
Preset (°C) - - - 30 - 30 - - -
- - - - - - LL LL -
- - - - - - L L -
Crust colour setting - - - - - - M M -
- - - - - - D D -
- - - - - - DD DD -
Preset - - - - - - M M -
1-VITAL - table of programmed phases
54
GB
/ 210