Dialogic IMG 1004 User Manual
Page 92
Installation and Setup
84
yiaddr --> IP Address of the IMG 1010 being loaded
subnetmask --> Subnet mask of the IMG 1010 being loaded
giaddr --> IP Address of the Gateway connected to the IMG 1010
file --> System Software Filename. If loading software from SD Card then this
is the filename of the software being loaded. Load this file onto the SD Card.
Host flag --> The Host Flag informs the IMG 1010 of configuration details such
as T1 or E1, Boot from SD card or Boot from FTP Server, and a few other
configuration details. See Setting Host Flags.
siaddr --> IP Address of FTP server. Also used as an NTP server.
sname --> Optional, not currently used. Do not edit or problems may occur
6.
Change the Host Flag to "Retrieve IMG Build from SD Card".
Host Flag Values
32 = Boot from SD Card, T1 system
34 = Boot from SD Card, E1 system
Example: The following is a T1 system booting from SD Card. Refer to the file Setting
Host Flags to follow the example
Boot From SD card = 32
T1 system = add +00
Host Flag Value = 32
The Host Flag for a T1 system booting from SD Card = 32
7.
Edit the bootup.cfg file to reflect the new Host Flag value
8.
Edit the System Software Filename in the bootup.cfg file to reflect the new software
file being loaded. (Ex: img1010_ver1033123_0101.bin)
9.
Edit the rest of the bootup.cfg file to reflect your network values.
10.
Save the bootup.cfg file.
11.
Remove the SD card from the SD Writer.
12.
Insert the SD card into the SD slot on the Front Panel of the IMG.
13.
Power-up the IMG 1010. The fans on the IMG 1010 will run at full speed while
diagnostics are running and software is being loaded
14.
The LCD screen will show the following:
While software is loading to IMG 1010 the LCD screen will display the following
MAC: 00:20:1C:04:03:11 ID:0101
SDC Loading
After the software has loaded to IMG 1010 the LCD screen will display the following
MAC: 00:20:1C:04:03:11 ID:0101
Load OK/Jumping to Load
After software is done loading, the LCD screen will display the node info and the fans
will slow to normal operation
Node Name: IMG1010
Node ID: 255
15.
The loading of software and configuring of network information is now complete. The
IMG 1010 is now ready to be configured.
Next Task
Starting GateControl EMS