Steps – Dialogic IMG 1004 User Manual

Page 160

Installation and Setup

152

Steps

Insert the SD Card into an SD Writer connected to a PC.

On the SD Card is a file named bootup.cfg. Open this file.

Below is what the SD Card bootup.cfg information should look like.

#################################################

# INSTRUCTIONS

#1. Edit values as required, as described below.

# Change IP Address, Subnet Mask, and Gateway IP Address to the actual #values for the

IMG.

# If you change the version of IMG System Software on the FTP Server #or the SD card,

make sure you change the System Software Filename #value.

# Make sure Host Flag is set appropriately for your configuration and #Boot method

# Calculate boot flag by adding values based on desired system attributes

# For a T1 system: add 0

# For an E1 system: add 2

# To boot from a FTP Server: add 0

# To boot from a SD Card: add 32

# For LBR codecs (512 ch/mod): add 0

# For LBR + ILBC codecs (336 ch/mod): add 16

# For LBR + ILBC + Wireless codecs (336 ch/mod): add 24

# An example host flag for a T1 system booting from the SD card with LBR + iLBC codecs

would = 48 (0+32+16)

# Change Server Address to the actual address of the FTP server.

# The Server Name is not used at this time.

#2. After editing this file: save file, remove SD card, insert SD card #in the IMG, power-up

the IMG.

#_______________________________________________________________________

# IMG bootup configuration file

# IP Address

yiaddr=192.168.3.103

# Subnet Mask

subnet mask=255.255.255.0

# Gateway Address

giaddr=192.168.3.10

# System Software Filename

file=/excelsw/ftpBuilds

# Host Flag

host flag=0

# Server Address for File transfer and SNTP operation.

siaddr=192.168.1.100

# Server Name (Optional, not currently used)

sname=factorydefault

#################################################