Dialogic IMG 1004 User Manual
Page 128
Installation and Setup
120
Configure GCEMS and Start Linux Services - IMG 1004
Topic Location:
IMG 1004-Installation and Setup Guide > IMG 1004-Software Installation and Setup
Before You Begin:
The IMG 1004 should be unpacked, mounted, and connected power to the GCEMS server.
See the manufacturer's instructions for installation procedures.
The GateControl EMS software must be installed. See
Installing GCEMS Software
.
Acquire IP Addresses for the IMG 1004.
Acquire the MAC address of the IMG 1004 from tag on rear of unit.
Procedure:
Follow these steps to setup the GCEMS Server.
1.
Connect to the GCEMS Server.
2.
Login as:
user: excelsw
password: excelsw
3.
If a DNS server will be needed in your network you will need to configure a DNS server.
To configure DNS server on GCEMS server follow next few steps.
4.
In the RedHat GUI select System Settings > Network and the following screen below will
appear.
5.
Select the DNS tab and enter a hostname for the DNS server in the Hostname field.
6.
Enter Primary and Secondary IP addresses for the primary and secondary DNS servers.
7.
Close the network configuration screen.