Dialogic IMG 1004 - Manual (Page 25)

IMG 1010 - Hardware Installation
17
Connecting AC Power - IMG 1010
Topic Location: IMG 1010-Installation and Setup Guide > IMG 1010-Hardware
Installation
Related Topic
AC Power Information (in On-line Help)
Overview
The IMG 1010 supports an AC power option to support domestic and international
customers. The AC power module is located at the rear of the docking station. The
AC receptacle connects to an internal power supply that supplies DC voltages to the
motherboard. (12 V DC for IMG 1010)
Warnings/Cautions
 Ensure the AC power module switch is set to O (Off) prior to connecting the IMG
1010 to the AC power source.
 Do not ground the AC unit using the external grounding points located at the
rear of the unit. These grounding points are for DC unit grounding only.
 The power up sequence will only start when the tray is fully seated into the
docking station, to ensure that the main board does not power up until the
system is properly seated.
Procedure
Complete the following steps to connect AC power to the chassis.
1. Plug the AC power cable into a grounded outlet.
2. Plug AC cable into the receptacle on the AC power module.
3. Insert other end into a grounded wall outlet, uninterruptible power supply (UPS),
or surge protector.
4. Press switch on the AC power module to I (On).