Dialogic IMG 1004 User Manual

Page 62

Installation and Setup

Create the ntp.conf file.

As a Super User Create the ntp.conf file. Go to

/opt/cantata/common/osconfig (Software 10.3.x to 10.5.0)

/opt/dialogic/common/osconfig (Software 10.5.1 +)

Run the ntp configuration script:

#./xlntp

Enter IP Address and Subnet mask when prompted as appropriate for your

configuration.

Move the ntp file to the /etc directory. (

mv ntp.conf /etc

). See Sample

ntp.conf File.

Start the services nfs, vsftpd, dhcpd, and ntp

As a Super User, start all the services and configure them to restart when

GCEMS server is rebooted. Enter the following commands to start the nfs server

#/sbin/service nfs start (Start the nfs service)

#/sbin/service nfs status (Verify whether nfs is running or not)

#/sbin/chkconfig nfs on (Configure nfs service to restart after a reboot of

GCEMS)

#/sbin/chkconfig nfs --list (Verify that runlevels 3,4 and 5 are all on.)

Example: nfs 0:off 1:off 2:on 3:on 4:on 5:on 6:off

Enter the following commands to start vsftpd service

#/sbin/service vsftpd start (Start the vsftpd service)

#/sbin/service vsftpd status (Verify whether vsftpd is running or not)

#/sbin/chkconfig vsftpd on (Configure vsftpd service to restart after a reboot

of GCEMS)

#/sbin/chkconfig vsftpd --list (Verify that runlevels 3,4, and 5 are all on.)

Enter the following commands to start dhcpd service

#/sbin/service dhcpd start (Start the dhcpd service)

#/sbin/service dhcpd status (Verify whether dhcpd is running or not)

#/sbin/chkconfig dhcpd on (Configure dhcpd service to restart after a reboot

of GCEMS)

#/sbin/chkconfig dhcpd --list (Verify that runlevels 3,4, and 5 are all on.)

Enter the following commands to start ntp service

#/sbin/service ntp start (Start the ntp service)

#/sbin/service ntp status (Verify whether ntp is running or not)

#/sbin/chkconfig ntp on (Configure ntp service to restart after a reboot of

GCEMS)

#/sbin/chkconfig ntp --list (Verify that runlevels 3,4, and 5 are all on.)

Once these services are running and the IMG software build is available the

software can be downloaded. See

IMG 1010-Downloading System Software