Dialogic IMG 1004 - Manual (Page 137)

IMG 1004 - Software Installation and Setup
129
5. GCEMS is now started. Verify that all processes are running by entering the following
command:
$ ps -ef |grep Man
You should see the following output showing all the processes running for GCEMS
Starting GCEMS through Telnet Session or using Terminal
1. Login to the GCEMS server as user excelsw.
username: excelsw
password: excelsw
2. To start the GCEMS processes through Telnet or Terminal, go to:
/opt/cantata/IMG/GateControlEMS/bin (Software 10.3.3 to 10.5.0)
or
/opt/dialogic/IMG/GateControlEMS/bin (Software 10.5.1 + )
folder. In each you can find the StartGCEMS file. Execute the following
command.
$ ./StartGCEMS
3. At this point GCEMS will begin the starting process. All the screen captures
above apply when starting GCEMS through telnet or terminal program. The
screen capture you will see will depend on whether the system has been
configured previously or not.
4. Once GCEMS has been started, verify all the processes have started also by
executing ps -ef|grep Man command shown above.
Next Task
Starting ClientView