Dialogic IMG 1004 - Manual (Page 115)

107
IMG 1004 - Software Installation and Setup
Software Installation Overview - IMG 1004
Topic Location: IMG1004-Installation and Setup Guide > IMG 1004-Software
Installation and Setup
Overview on Downloading Software to IMG 1004
The IMG 1004 can get its software load in one of a three different ways.
1. Software is loaded through use of an FTP server. The Linux Server that is setup
for use with GCEMS can also be setup to use as an FTP server. See the
procedure in this topic below
2. Software is loaded through use of an SD Card, which can be inserted into the
front panel of the IMG 1004
IMG 1004 - Downloading System Software from an SD Card
3. A combination of using the SD Card and FTP Server. The SD Card is used to
assign IP and FTP addresses and the FTP server holds the files needed for the
download.
IMG 1004 - Downloading System Software Using a Boot File on an SD Card
Items Required for Installation
For a list of items required click on the link: Items Required for Installation.
Minimum Server Specifications
For a detailed explanation on minimum requirements click on link: Dell Server
Configuration Details
This section documents the installation of software on your GCEMS server if it is not
factory installed. If you purchased your server through Dialogic or IMG 1004 supplier
the software is already installed unless specifically ordered without software. If
software is installed proceed to Setting Up the GateControl EMS Server.
If you purchased your server from Dialogic without software installed, or purchased
from a 3rd party, you must install software.
Items Required for Installation
For a list of items required click on the link: IMG 1004 - Items Required for
Installation .
Minimum Server Specifications
For a detailed explanation on minimum requirements click on link: Dell Server
Configuration Details.