Comtech EF Data CDM-700 - Manual (Page 92)

CDM-700 High Speed Satellite Modem Revision 5
Front Panel Operation MN/CDM700.IOM
6–38
RTS is the same as TA, and CTS is the same as CA. The selections operate as follows:
Selection Description
Normal CTS = RTS
Fault
CTS = RTS when no fault is present. CTS is not asserted when a
fault is present
Intfc1 HSSI: Æ Alarm
Intfc1 Ext-Clock Alarm:
Alarm Fault Mask ( E)
Ext-Clock Alarm is the alarm generated for the HSSI Tx Clock .Alarm when the HSSI Cable is
disconnected or faulty.
Select Alarm, Fault, or Mask using the
◄ ► arrow keys. Press
ENTER
.
6.3.1.6.1 (CONFIG:) Intfc2 (CDI-60 HSSI Interface)
The CDM-700 can be configured with a second CDI-60 HSSI interface board plugged into interface
Slot2 (Intfc2). The menus are identical to what is presented in 6.3.1.6 (CONFIG:) Intfc1 (CDI-60
HSSI Interface) except that Intfc2, rather than Intfc1, is displayed in all menus.
6.3.1.7 (CONFIG:) Intfc1 (CDI-70 Gigabit Ethernet Interface)
There is a single RJ-45 port on the CDI-70 Gigabit Ethernet Interface.
The menus depicted in this section pertain to the CDI-70 Gigabit Ethernet Interface installed in
Slot1. The CDM-700 supports either a single Gigabit Ethernet Interface (Intfc1) or Dual Gigabit
Ethernet interfaces (Intfc1 and Intfc2). The menus for Intfc2 are identical to what is presented in
this section except that Intfc2, rather than Intfc1, is displayed in all menus.
Intfc1 Gigabit Ethernet:
Tx Rx Man Stats SWOP NEG(E)
Select Tx, Rx, Man, Stats, SWOP (Swith Operation), or NEG (Negotiation) using the ◄ ►
arrow keys. Press
ENTER
.