Comtech EF Data CDM-700 - Manual (Page 80)

CDM-700 High Speed Satellite Modem Revision 5
Front Panel Operation MN/CDM700.IOM
6–26
Comp Tx Data/Sym Rate:
034.36800/23.484800 (E)
This display shows the Composite Tx Data Rate (Mbps) that is the sum of all enabled terrestrial
ports. The Symbol Rate (Msps) is the IF Symbol Rate based on the Composite Data Rate,
Overhead, Modulation, and Coding.
Press
ENTER
or
CLEAR
to return to the previous menu.
If Intfc1 Port1 Tx: Æ Ena/Dis is selected:
Intfc1 Port1 Status
Enable Disable (E)
This selection activates or deactivates the transmit (Tx) side of Port1. Disabling the Tx port
deactivates the port and changes the data rate to 0.
Select Enable or Disable using the
◄ ► arrow keys. Press
ENTER
.
If Intfc1 Port1 E3/T3/STS1: Æ Rx is selected:
Intfc1 Port 1 Rx: Alarms Inv Data
Buf Clk Ena/Dis (E)
Select Alarms, Inv, Data, Buf, Clk or Ena/Dis using the
◄ ► arrow keys. Press
ENTER
.
If Intfc1 Port1 Rx: Æ Alarms is selected:
Intfc1 Port1 Rx Alarms:
Rx-AIS Buffer-Slip (E)
Select Rx-AIS or Buffer-Slip, using the
◄ ► arrow keys, to configure either as an Alarm or
Fault condition. Press
ENTER
.
If Intfc1 Port1 Rx Alarms: Æ Rx-AIS is selected:
Rx-AIS Alarm:
Alarm Fault Mask (E)
This selection will affect the event reporting status upon detection of a Rx AIS condition, and
subsequently the switching logic, when the modem is in a 1:1 redundancy configuration.
Select Alarm, Fault, or Mask using the
◄ ► arrow keys. Press
ENTER
.
If Intfc1 Port1 Rx Alarms: Æ Buffer-Slip is selected: