Comtech EF Data CDM-700 - Manual (Page 61)

CDM-700 High Speed Satellite Modem Revision 5
Front Panel Operation MN/CDM700.IOM
6–7
6.3.1 (SELECT:) CONFIG
CONFIG: Remote Tx Rx
Intfc1 Intfc2 Ref Aux
The submenus available are:
Selection Submenu Description
Remote
[Remote Control] - used to define whether the unit is controlled locally or
remotely. (See Important Note.)
Tx
[Transmit] - used to define, on a parameter-by-parameter basis, the Tx
configuration of the unit. These submenu branches would be used to
change, for example, just the Tx Frequency.
Rx
[Receive] - used to define, on a parameter-by-parameter basis, the Rx
configuration of the unit. These submenu branches would be used to
change, for example, just the Rx Frequency.
Intfc1
or
Intfc2
[Interface] - used to configure Interfaces plugged into Slot 1 or Slot 2 on
the back of the unit. The menus change depending on the type of
interface – as of this manual revision, Dual E3/T3/STS-1, Dual G.703,
OC3, HSSI, and Gigabit Ethernet (GbE) are available.
Ref
[Reference] - used to configure the source of the modem reference
frequency.
Aux
[Auxiliary] - used to enable Redundancy. In 1:1 operation, allows the
online unit to force switchover.
IMPORTANT
The modem may be monitored over the remote control bus at any time. When
in Local mode, however, configuration parameters may only be changed
through the front panel. Conversely, when in Remote mode, the unit may be
monitored from the front panel, but configuration parameters may only be
changed via the remote control bus.