Comtech EF Data CDM-700 - Manual (Page 84)

CDM-700 High Speed Satellite Modem Revision 5
Front Panel Operation MN/CDM700.IOM
6–30
Intfc1:
Æ Port2
Intfc1 Port2 E3/T3/STS1:
Type Line-Code Tx Rx (E)
Functionality for all submenus under (CONFIG:) Intfc1 Æ Port2 is identical to what has been
outlined previously under (CONFIG:) Intfc1 Æ Port1. For a full explanation of all submenus
under (CONFIG:) Intfc1 Æ Port2, refer to these previous sections.
Intfc1:
Æ Ext-Clk
Intfc1 Ext-Clk Freq:
1.000 Mbps ( E)
Set the input frequency for the Ext-Clk connector on the E3/T3/STS-1 Interface Card by using the
▲ ▼ arrow keys. The Ext-Clk Frequency source selections are: 0 (None), 1, 2, 5, 10, 2.048,
34.368, 44.736, and 51.84 MHz. The input level ranges from 0.5 to 5.0 volts peak-to-peak.
Once the Ext-Clk input frequency has been edited, Press
ENTER
.
6.3.1.4.1 (CONFIG:) Intfc2 (CDI-10 Dual G.703 Interface)
The CDM-700 can be configured with a second CDI-10 Dual G.703 Interface board plugged into
interface Slot2 (Intfc2). The menus are identical to what is presented in 6.3.1.4 (CONFIG:) Intfc1
(CDI-10 Dual G.703 Interface) except that Intfc2, rather than Intfc1, is displayed in all menus.