Comtech EF Data CDM-700 - Manual (Page 60)

CDM-700 High Speed Satellite Modem Revision 5
Front Panel Operation MN/CDM700.IOM
6–6
6.2 Opening Screen
The opening ‘welcome screen’ shown here is
representative of what displays whenever power is first
applied to the unit (the Firmware Version may differ).
Pressing any key displays the top-level Select menu.
6.3 SELECT: (Main) Menu
IMPORTANT
The following menus are presented using CDI-10 G.703, CDI-60 HSSI, and
CDI-70 GbE Interfaces. The CDI-10 G.703 Interface is used to present all
menus. The difference is noted in
(SELECT:) Config Æ Intfc1, where each
interface is specifically referenced.
SELECT: Config Monitor
Test Info Save/Load Util
Move the cursor to the desired choice using the ◄ ► arrow keys, then press
ENTER
. The
following table describes the function of each menu branch:
Selection Menu Branch Description
Config
[Configuration] Provides selections for the desired Interface, Transmit,
and Receive operations
Monitor
Permits the user to monitor the alarm status of the unit, to view the log of
stored events, and to display the Receive Parameters screen.
Test
Permits the user to configure the modem into one of several Test modes,
example: CW and Loopback
Info
[Information] Provides a summary/display of the Interface, Transmit,
Receive, and M&C configurations.
Save/Load Permits the user to save and retrieve up to 10 different modem configurations.
Util
[Utility] Permits the user to perform miscellaneous functions, such as
setting the Real-Time Clock, adjusting the display brightness, etc.