Comtech EF Data CDM-700 - Manual (Page 64)

CDM-700 High Speed Satellite Modem Revision 5
Front Panel Operation MN/CDM700.IOM
6–10
If Ethernet Config: Æ Address is selected:
Ethernet IP Address/Range:
010.006.030.139/16 ()
The operator uses this menu to set the modem’s management IP address and subnet mask (range).
This is the address used by external applications to access and control the modem using the SNMP,
HTTP or Telnet interfaces. This also is the address used to upgrade the device firmware using FTP.
Edit the IP Address/Range address by selecting the digit to be edited, using the ◄ ► arrow keys.
The value of the digit is then changed using the ▲ ▼ arrow keys. Press
ENTER
.
If Ethernet Config: Æ MAC is selected:
M&C Port MAC Address:
00-06-B0-00-47-12
This is a ‘read only’ status window that displays the factory program MAC address for the
Ethernet management interface. Press
ENTER
or
CLEAR
to return to the previous menu.
Note: The preceding address is representative of a typical MAC address.
If Ethernet Config: Æ SNMP is selected:
SNMP: Community Traps
( E )
This is a ‘read only’ status window . Submenus enable setting of the destination IP address for
SNMP traps. Select Community or Traps using the ◄ ► arrow keys, then press
ENTER
.
If SNMP Æ Community is selected:
SNMP Community:
Read ( E )
This menu is the entry point into setting the Read, Write, and Trap community strings used for
SNMP. Use the
▲ ▼ arrow keys to toggle between Read, Write, and Trap, then press
ENTER
to drop into the next level menu.