Comtech EF Data CDM-700 - Manual (Page 167)

CDM-700 High Speed Satellite Modem Revision 5
Remote Control MN/CDM700.IOM
11–17
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
IP Address IPA= 18 bytes Command or Query.
Used to set the IP address and network prefix for the
10/100 BaseTx Ethernet management port, in the format:
xxx.xxx.xxx.xxx.yy, where:
xxx.xxx.xxx.xxx is the IP address, and
yy is the network prefix (0-31)
Example: 010.006.030.001.24 IPA=
IPA?
IPA*
IPA#
IPA? IPA=
xxx.xxx.xxx.xxx.yy
Gigabit
Interface
Management
IP Address GIP= 19 bytes Command or Query.
Used to set the management IP address and network prefix for an
GBEI interface card, in the format:
sxxx.xxx.xxx.xxx.yy, where:
s is the slot number of interface card,
xxx.xxx.xxx.xxx is the IP address, and
yy is the network prefix (0-31)
Example: 1010.006.030.001.24 (set IP address on Interface slot 1 to
10.6.30.1/24 ) GIP =
GIP?
GIP*
GIP#
GIP?s GIP=
sxxx.xxx.xxx.xxx.yy
Unit Test
Mode TST= 1 byte Command or Query.
CDM-700 Test Mode, where:
0=Normal Mode (no test)
1=IF Loopback
2=Digital Loopback
3=I/O Loopback
4=RF Loopback
5=Tx CW
6=Tx Alternating 1,0
Example: TST=3 (I/O Loopback) TST=
TST?
TST*
TST# TST? TST=x
Demodulator
Mask All
Faults MRF= 1 byte Command or Query
0=Unmask All Demodulator Faults(Normal Fault Reporting).
1=Mask All Demodulator Faults(All Faults Ignored).
Example.:MRF =1; MRF=
MRF?
MRF# MRF? MRF=x
Unit Alarm
Mask MSK= 3 bytes Command or Query.
Alarm mask conditions, in form abc, where:
a=Rx AGC Alarm (0 = active, 1 = masked)
b=Eb/No Alarm (0 = active, 1 = masked)
c=BER Alarm (0 = active, 1 = masked)
Example: MSK=010 MSK=
MSK?
MSK*
MSK# MSK? MSK=abc