Comtech EF Data CDM-700 - Manual (Page 175)

CDM-700 High Speed Satellite Modem Revision 5
Remote Control MN/CDM700.IOM
11–25
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Modem Global
Configuration MGC= 69 bytes Command or Query.
a=Tx Frequency *TFQ
b=Tx Datarate (Read-Only) *TDR
c=Tx FEC Type *TFT
d=Tx FEC Code Rate *TCR
e=Tx Modulation Type *TMD
f=Tx Spectrum Invert *TSI
g=Tx Scrambler Enable *TSC
h=Tx Power Level *TPL
i=Tx Carrier State *TXO
j=Tx Alpha Rolloff *TAR
k=Rx Frequency *RFQ
l=Rx Datarate (Read-Only) *RDR
m=Rx FEC Type *RFT
n=Rx FEC Code Rate *RCR
o=Rx Demodulation Type *RMD
p=Rx Spectrum Invert *RSI
q=Rx Scrambler State *RDS
r=Rx Sweep Width *RSW
s=Rx Eb/No Alarm Point *EBA
t=Rx Alpha Rolloff *RAR
u=Rx Adaptive Equalization *AEQ
v=External/Internal Reference *ERF
w=Test Mode (Read-Only) *TST
x=Unit Alarm Mask *MSK MGC=
MGC?
MGC#
MGC* MGC? MGC=aaaa.aaaabbb.b
bbbbbcdefghhh.hijkkkk.
kkkklll.llllllmnopqrrrss.st
uvwxxx
Gigabit
Interface
Management
MAC Address GMC? N/A Query Only.
s=Defines which interface slot (1 or 2)
Example get MAC address for Gigabit in Slot One
GSW?1
GSW=1 s0006B0004717 GMC?
GMC*
GMC#
GMC?s Gigabit Interface
Management
MAC Address
Gigabit
Interface
Software
Revision GSW? N/A Query Only.
s=Defines which interface slot (1 or 2)
Example get Software Revision for Gigabit in Slot One
GSW?1
GSW=1 FW/12738-,1.1.8,02/16/07 GSW?
GSW*
GSW#
GSW?s Gigabit Interface
Software Revision
Gigabit Global
Configuration GGC= 23 bytes Command or Query.
a=Interface Slot 1 or 2
b=Tx Enable (0=Disabled, 1=Enabled) *TIE
c=Tx Datarate (in megabits per second) *ITR
d=Rx Enable (0=Disabled, 1=Enabled) *RIE
e=Rx Datarate (in megabits per second) *IRR GGC=
GGC?
GGC#
GGC* GGC?a GGC=abccc.ccccccdeee.e
eeeee